The Liquid Adhesive Approach:

Apply liquid adhesive on your scalp directly in front the natural hairline.

Do not use Qtips. The fibers will bond with the adhesive.

Follow the manufacturer’s directions regarding cure times.

Optional: Use a wig cap to protect your hair.

Begin by lightly rubbing the liquid adhesive along your hairline.

Apply the liquid adhesive at the nape. Make sure you drop your chin toward your chest water wave lace front wig.

Allow the liquid glue to dry completely.

While the full lace hair unit is on the wig head, you will need to pull it into a tight bun at the crown.

Use water to subdue flyways.

Place the full lace edge on your forehead. Use a fine-tooth comb to push the baby hair back.

Continue to adjust full lace from the top of your head to the nape.

Notice: Press the lace tightly when applying the full laced wig’s lace to the nape.

After the adhesive sets and the lace has dried, it is important not to touch the forehead area.

You can secure the bonding process with a tight wrap or headband.

Avoid heavy sweating.

Tape Method

Make sure to cut the full-lace wig and fit your hairline with pre-bond double-sided adhesive tape.

Most tapes come precut.

Optional: Use a wig cap to protect your own hair.

Place the prebond double-sided tape strips along the entire perimeter of the head.

Next, apply the lace from the full lacewig. Press down gently on the strips. To ensure your full lace doesn’t lift or tug on your skin, you need to remember to do this when you reach your nape.

You can complete the bonding process by wrapping your head in a scarf. Do not sweat excessively or drink water while wearing a full-lace wig for more than 24 hours.

Combination of Both of the Methods Previously Mentioned:

Apply liquid adhesive to your hair in front your natural hairline. You can use your finger or a flat cosmetic brush.

Let the liquid adhesive dry completely to make sure it is clear and tacky to touch.

Make sure to cut the full-lace wig and fit your hairline with pre-bond double-sided adhesive tape.

Optional: Use a wig cap to protect your hair.

Place the pre-bond tape strips double-sidedly in front and around your head.

Apply the full lace by using a little pressure on the strips. Start at your forehead and work your way to the side of the head. To ensure your full lace doesn’t lift or tug on your skin, you need to remember to do this when you reach your nape.

For the best bonding, wrap your head around with a scarf. Do not sweat excessively or drink water while wearing a full-lace wig for more than 24 hours.